To Next PageTo Next Page
Need help?Do you have a question about the Aqualisa Bath and is the answer not in the manual?
General| Brand | Aqualisa |
|---|---|
| Model | Bath |
| Category | Bathroom Fixtures |
| Language | English |
Safely detach the overflow filler outlet from the body assembly and set aside.
Carefully unscrew and remove the bath waste clicker assembly from the waste body.
Insert the bath waste, ensuring correct rubber washer alignment with the bath base.
Pass the bath waste clicker through the bath and secure it to the waste body assembly.
Connect the bath waste to a suitable waste pipe.
Position the outlet body assembly at the rear of the bath, ensuring proper washer alignment.
Pass the overflow filler outlet through the bath and secure it to the body assembly.
Remove the inlet blanking plug and attach the flexible hose to the blended inlet connection.
Connect the flexible hose to the blended supply pipe, ensuring compliance with regulations.
Unscrew the clamping nut and remove the waste pipe from the waste assembly.
Remove the clamping nut and sealing washer from the waste pipe and set aside.
Carefully pull the waste pipe away from the outlet assembly.
Reassemble the unit using the longer waste pipe by reversing the above procedure.
Instructions on how to use the plug fitting to engage or disengage the drain.
Guidance on cleaning the overflow filler system using soft cloth and washing up liquid.
