AquaMaster Pro AMP5000 - Page 19

AquaMaster
®
Owner’s Manual 1/21/2021 19
Advanced Customer Settings, Cont.
Step 17 Set Gallons or Liters
Display reads “Gallons (or Liters) x 100.”
To Set Gallons or Liters
L. Press Change to toggle between gallons and liters. Choosing “Gallons” sets the controller to
English units, and choosing “Liters” sets it to metric units.
 When the desired units are displayed, press Set.
Step 18 Set Time Format
Display reads “12” if gallons were chosen or “24” if liters were chosen.
To Set Time Format
M. Press Change to toggle between 24 and 12. This controls the selection of a 12-hour (AM/PM)
or 24-hour clock. If 24-hour, 00=midnight.
 When the desired time format is displayed, press Set.
Step 19 Set Time of Day
Display reads “Set Time” and “12” (or “24”).
To Change Time of Day
N. Press Change until the current time is displayed. Default is 12 PM.
Note: Set time to the nearest hour.
 When the desired time is displayed, press Set.
Step 20 Set Regeneration Time
Display reads “Set Reg. Time” followed by the current regeneration time that is set (02).
To Change Regeneration Time
O. Press Change. Default is 2 AM.
 When the desired regeneration time is displayed, press Set.
Note: Whenever you experience an electrical outage, check your controller for the correct time.
Make any necessary corrections.
Programming is now complete.