To Next PageTo Next PageWhat to do if AquaSource Bathroom Fixtures spout/ showerhead is leaking?
If your AquaSource Bathroom Fixtures spout or showerhead is leaking, it might be due to a damaged cartridge. The solution is to remove the handle and replace the cartridge.
How to fix a leak under the handle of AquaSource 873-W4801 Bathroom Fixtures?
If there is a leak from under the handle of your AquaSource Bathroom Fixtures, it is likely that the cartridge is damaged. You will need to remove the handle and replace the cartridge.
Why is there an inconsistent water pattern in my AquaSource Bathroom Fixtures?
An inconsistent water pattern in your AquaSource Bathroom Fixtures usually means the showerhead is dirty or has debris. You should remove the showerhead and check for any debris clogged at the shower connection and the showerhead’s spray nozzle for any buildup.
Read and understand this entire manual before attempting to assemble, operate, or install the product.
Ensure all parts are present by comparing them with the package and hardware contents lists.
Verify wall hole sizes and positions, including diameter and depth, for proper installation.
Clear debris and old sealant from the shower and bath area for threaded connections.
Wrap threads with sealant tape and connect water supplies and outlet pipes to the valve body.
Insert shower arm through flange, wrap with sealant tape, and thread into the wall elbow.
Wrap threads with sealant tape and twist spout clockwise until flush with the finished wall.
Twist the plastic cap from the valve body in a clockwise direction.
Place handle, turn on water, flush lines for one minute each, check for leaks, and shut off water.
Hand-tighten the diverter onto the shower arm.
Insert sealing washers, hand-tighten hose to diverter and hand shower.
Twist showerhead onto diverter clockwise and tighten with a wrench, using a cloth for protection.
Place the hand shower into its holder on the diverter.
Secure escutcheon with screws, then attach handle using the handle screw and Allen wrench.
Unscrew the screw to remove inverter, then unscrew the sleeve.
Remove the red limit stop ring from the valve.
Turn valve stem counterclockwise to set the desired maximum water temperature.
Reinstall the limit stop ring to set the stem's engagement position.
Turn the limit ring to adjust hot water flow or remove it entirely.
Fasten the sleeve and reinstall the inverter and screw using a Phillips screwdriver.
Detailed steps for removing the old cartridge and its components.
Clean carefully with a damp cloth and mild soap. Avoid harsh chemicals or abrasives.
Identify problems like leaks or inconsistent flow and their corrective actions.
General| Brand | AquaSource |
|---|---|
| Model | 873-W4801 |
| Category | Bathroom Fixtures |
| Finish | Chrome |
| Flow Rate (gallons per minute) | 1.2 |
| Number of Handles | 2 |
| Handle Style | Lever |
| Mounting Location | Deck mount |
| Number of Holes Required | 3 |
| Maximum Deck Thickness (in.) | 1.5 |
| Valve Type | Ceramic Disc |
| ADA Compliant | Yes |
| Material | Brass |
| Warranty | Limited Lifetime |
