Why does my AquaSure Water System tank take so long to fill?
If your AquaSure Water System's tank is taking a long time to fill, it could be due to insufficient water pressure. Ensure incoming water pressure is above 40 psi. If it's not, install a booster pump or permeate pump. Additionally, lower water temperature can affect the system's performance; consider installing a booster pump or permeate pump to compensate.
What to do if my AquaSure Water System does not shut off?
If your AquaSure Water System doesn't shut off, the automatic shut-off valve may be defective. Test it by closing the tank ball valve; if the system continues producing water, replace the valve. Alternatively, the incoming water pressure might be too low (install a booster pump or permeate pump). It's also normal for the system to run constantly if it's feeding multiple outlets or an outlet that demands water continuously.
Why is there no water coming from my AquaSure AS-PR50S Water System faucet?
If there's little to no water at your AquaSure Water System dispensing faucet, first check if the water is shut off at the stop valve (open it). Also, ensure the Flowlok is in the open position (lever should be lowered). Other potential issues include a crimped output line (reroute it), a tank that isn't pre-charged (empty and recharge it), a defective tank (replace it), a tank that hasn't filled yet (allow it to refill), insufficient water pressure (install a booster pump or permeate pump), or incorrect installation (check the installation guide).
Why does my AquaSure AS-PR50S Water System water taste bad?
General| Model | AS-PR50S |
|---|---|
| Type | Under Sink |
| Dimensions | 380 x 240 x 450 mm |
| Weight | 8.5 kg |
| Product Type | Water Purifier |
| Purification Technology | Reverse Osmosis |
| Storage Tank Capacity | 12 Liters |
| Stages | 5 |
| Filter Life | 6-12 months |
| Daily Production | 50 GPD (Gallons Per Day) |
| Warranty | 1 year |
To Next Page
