Common setting
1． Heat/Cool Mode
Press the Mode button to switch from one mode to another.
（
Available only in heat and cool machine.
）
2． Required pool water temperature
It can be adjusted both when the machine is on or off.
A. Press UP-ALLOW key or DOWN-ALLOW key to set to your required pool
water temperature.
B. The numbers in the LED screen will flash during your operation.
C. After five seconds, it will stop flashing and be saved, the LED screen will return
to the permanent display.
D. When you want to check the temperature, press UP-ALLOW key or
DOWN-ALLOW key to see the current setting.
3． Time setting
It can be adjusted both when the machine is on or off.
A. Press key to set time according to your local time.
B. Time on the LED screen flashes.
C. Press again then press UP-ALLOW key or DOWN-ALLOW key
to set hour.
D. Before it stops flashing, press and then press UP-ALLOW key or
DOWN-ALLOW key to set minutes
E. After setting, press and the water temperature will appears. 30 seconds later, it
will stop flashing and the LED screen will return to the permanent display.
13
To Next Page
