Aquverse B11A (3H) User Manual

!
B11A$(3H)$Aquverse$Water$Cooler$Troubleshooting$Instructions$Supplement$
****Warning$do$not$plug$water$cooler$in$until$water$bottle$is$in$place$and$dispensing$water$through$the$faucets****$
To$find$the$Aquverse$warranty$please$go$to$www.aquverse.com$
Parts$Extraction:!
1. To$Remove$Baffle$From$Top$of$the$Water$Cooler$
a. Turn!the!Baffle!counter!clockwise!till!the!open!arrow!meets!the!corresponding!arrow!on!the!top!of!the!cooler!body!(see!
figure!A!and!B!below)!
!
!!!!!!!!!!!!!!!!!!!!! Figure!A! ! ! !!!!!!!!!!!!!!Figure!B!
b. Grip!baffle!from!two!opposite!sides!and!pull!upwards!out!of!the!cooler!body!!(see!figure!C!below)!
!
Figure!C!
2. To$Remove$Faucets$
a. Grip!faucet!in!hand!and!unscrew!faucet!counter!clockwise!(see!figure!D!below)!
!
Figure!D!
!
!
General$Information$Helpful$To$Trouble$Shooting$

Aquverse B11A (3H) Specifications

General

Cooling System	Compressor
Dimensions	12" W x 13" D x 41" H
Material	ABS Plastic
Power Consumption (Heating)	500W
Power Consumption (Cooling)	100W
Water Temperature Settings	Hot, Cold, Room

Summary

Parts Extraction

To Remove Baffle From Top of the Water Cooler

Instructions for removing the top baffle, including counter-clockwise rotation and upward pulling.

To Remove Faucets

Procedure for removing faucets by gripping and unscrewing them counter-clockwise.

Cooler Is Not Dispensing Water

Check Water Bottle and Probe

Verify bottle fullness, probe piercing, and cap security for dispensing issues.

Confirm Cooler is Not Frozen

Steps to check if the cooler is frozen, including baffle removal and bottle inspection.

Check Faucets for Flow

Inspect faucets to ensure water can flow through them when in the on position.

Cooler Is Not Dispensing Chilled Water

Check Cold Water Thermostat

Verify that the cold water thermostat is not turned to the off position.

Check Compressor Operation

Listen for compressor noise to determine if it is working correctly.

Adjust Cold Thermostat

Turn the cold water thermostat clockwise to its maximum setting.

Cooler Is Not Dispensing Hot Water

Check Hot Tank Switch

Ensure the hot tank switch at the back of the cooler is in the 'on' position.

Reset Hot Tank Button

Depress the hot tank reset button after unplugging the cooler and accessing the back.

Water Is Leaking

Identify Leak Source

Determine if the leak originates from internal components, faucets, or the top.

Check Top Leak Source

Inspect the water bottle for punctures or pinholes and ensure the cap is secure.

Check Faucet Leak Source

Verify faucets are screwed on tightly and check gasket condition; contact support if needed.

Address Internal Leaks

If the leak is internal, contact customer service for assistance.