Aquverse 1PH - User Manual

1PH
Angle stop fitting (size depends on your water source, adaptable fitting
provided in water line kit)
Adjustable crescent wrench
Quick connect (2 sided coupler for poly line, provided in water line kit)
Drill with a 3/8 bit
Safety Glasses (Wear these at all times during installation)
To find the Aquverse warranty please go to www.aquverse.com
Poly Tubing (provided in water line kit)
Water filter
WARNING: This product is intended for indoor use only. Outside temperatures can cause damage to all systems. Please use only inside your home or office.
Phillips head screw driver
For any needed assistance please call 1-866-872-5722
****Warning do not plug water cooler in until water line is in place and dispensing water
through the faucets****
Aquverse Water Cooler Installation and Troubleshooting Instructions
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES FOR INSTALLATION, OR THE
WARRANTY WILL BE VOIDED.
If you do not own the property where the unit will be installed, you need to contact the owner and obtain
approval before you install your cooler. If you are not comfortable with the installation procedure it is
recommended to have a professional licensed plumber complete the install for you.
WARNING: Do not use a saddle valve for installation or the warranty will be voided
Items You Need
Very sharp pair of scissors or a very sharp knife to cut tubing
Zip Ties (provided in water line kit)

Summary

Cooler Setup Guide

Initial Setup Steps

Determine the cooler's location and ensure it is not plugged in before starting.

Attaching the Water Filter

Follow instructions for correctly attaching the water filter to the cooler.

Re-attaching the Front Cabinet

Steps to properly secure the front cabinet after filter installation is complete.

Water Source Identification and Preparation

Locate Cold Water Source

Identify a suitable cold water connection point, typically found under the sink.

Confirm Water Source is Off

Shut off the water supply valve and drain existing lines before proceeding.

Water Line Installation Procedure

Connecting the Water Line Kit

Detailed steps for connecting the water line from the source to the cooler.

Filter Flushing and Cooler Operation

Flushing the Water Filter

Flush water through the filter to remove excess carbon before use.

Begin Using Your Cooler

Instructions on when and how to start using the water cooler.

Troubleshooting Common Cooler Issues

Cooler Not Dispensing Water

Steps to diagnose and resolve issues when no water is dispensed.

Cooler Dispensing Water But Not Chilled

Troubleshooting steps for when the cooler dispenses water but it is not cold.

Advanced Troubleshooting and Leak Resolution

Cooler Dispensing Water But Not Hot

Diagnose and fix issues when the cooler dispenses water but it is not hot.

Water Is Leaking

Identify sources of leaks and steps for resolution.

Cleaning and Maintenance Procedures

Cleaning Your Water Cooler

Step-by-step guide for cleaning the internal components of the water cooler.

Water Filter Replacement Guide

Replacing Your Water Filter

Instructions on how to safely remove and replace the water filter.

Aquverse 1PH Specifications

General

Water Temperature Settings	Hot, Cold, Room Temperature
Water Temperature	Adjustable
Cooling System	Compressor Cooling
Hot Water Temperature	185°F
Type	Water Dispenser
Cooling Capacity	2L/h
Heating Capacity	5L/h
Cold Water Temperature	37°F
Safety Features	Child safety lock on hot water