Aquverse 1PH - Water Filter Replacement Guide; Replacing Your Water Filter

STEP 8
STEP 1
Pull down gently on the filter until it is removed
STEP 5
STEP 2
Attach filter to filter head by pushing in, and turning to the right until it
stops
STEP 6
STEP 3
Secure the new filter into the filter cup to prevent movement
STEP 7
STEP 4
Slide the top cover back into position
Re-attach the screws to secure the top cover
STEP 8
For any needed assistance please call 1-866-872-5722
Lift the filter assembly up so that you can access the filter
TURN OFF WATER!
Remove the attached filter by turning to the left until it stops
Replacing Your Water Filter
Clean the cold tank with a clean dish towel, and water (do not use bleach
or any cleaners, you may use a small amount of soap if desired)
Remove the screw located at the top of the back of the water cooler
Lift upwards at the back of the top cover and pull towards you