Aquverse 5ph User Manual

Phillips head screw driver Angle stop fitting (size depends on your water source, adaptable fitting provided in water line kit)
Very sharp pair of scissors or a very sharp knife to cut tubing Adjustable crescent wrench
Zip Ties (provided in water line kit) Quick connect (2 sided coupler for poly line, provided in water line kit)
Poly Tubing (provided in water line kit) Drill with a 3/8 bit
Water filter Safety Glasses (Wear these at all times during installation)
First Steps
Determine where your cooler is going to be located and place it close to the determined area This drinking water system must be maintained in accordance with the manufacture's instructions
DO NOT PLUG IN (see instructions that are provided with filter)
A professional licensed plumber can perform the install or you can obtain the following items at your local hardware store: Maximum PSI = 10-125 psi/Capacity = 1500 gallons/Temperature = 35-100 F
Attaching Filter Re-attaching Front Cabinet
STEP 1
Place the bottom of the cabinet cover over the plastic L-shaped clips at the bottom of the cooler and press
down gently
STEP 1
STEP 2
Push the top of the cabinet cover into place and let slide up naturally and click into position
STEP 2
STEP 3
Insert the previously removed screw into the bottom of the cabinet cover
STEP 3
STEP 4
Re-attach the drip tray by pushing in
STEP 4
Locate Water Source
Aquverse Water Cooler Installation and Troubleshooting Instructions
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES
If you do not own the property where the unit will be installed, you need to contact the owner and obtain
approval before you install your cooler. If you are not comfortable with the installation procedure it is
recommended to have a professional licensed plumber complete the install for you.
Items You Need
****Warning do not plug water cooler in until water line is in place and dispensing water through the faucets****
Installation can be completed easily even without much knowledge of basic hardware and plumbing.
For any needed assistance please call 1-866-872-5722
Cooler Set Up
Filter Specifications
Remove the screw located at the bottom of the cabinet on the front of the cooler
Push the cabinet cover in at the top and pull down then towards you
Attach filter to filter head by pushing in, and turning to the right until it stops
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES
WARNING: This product is intended for indoor use only. Outside temperatures can cause damage to all systems. Please use only inside your home or office.
Remove the drip tray by pulling towards you

Aquverse 5ph Specifications

General

Cooling Method	Compressor
Heating Method	Internal Heating Element
Hot Water Temperature	185°F
Water Temperature Settings	Hot, Cold, Room Temperature
Material	Stainless Steel/Plastic
Safety Features	Child Safety Lock

Summary

Cooler Setup and Installation

Attaching Filter

Steps to attach the water filter to the filter head by pushing in and turning.

Locate Water Source

Instructions on finding and preparing the cold water source for connection.

Re-attaching Front Cabinet

Procedure for re-installing the front cabinet cover after setup.

Filter Specifications

Details on filter requirements including PSI, capacity, and temperature.

Water Line Installation Procedures

Locate the Cold Water Source

Guidance on identifying and connecting to the cold water faucet.

Confirm Your Water Source Is Off

Steps to ensure the water source valve is shut off before proceeding.

Installing Water Line Kit

Detailed steps for connecting the water line from source to cooler.

Filter Flushing and Initial Use

Flushing the Filter

Instructions on flushing the filter to remove carbon residue before use.

Begin Using Your Cooler

Information on when the cooler will reach optimal temperature after setup.

Cooler Troubleshooting Guide

Cooler Is Not Dispensing any Water

Troubleshooting steps for when the cooler fails to dispense water.

Cooler Not Chilled or Not Hot

Diagnosing and resolving issues with water temperature.

Water Leak and Cooler Cleaning

Water Is Leaking

Steps to identify and resolve water leaks from the cooler.

Cleaning Your Water Cooler

Instructions for cleaning internal components of the water cooler.

Replacing Your Water Filter

Filter Replacement Steps

Procedure for removing the old filter and installing a new one.