Aquverse 5ph - Water Line Installation Procedures; Locate the Cold Water Source; Confirm Your Water Source Is Off; Installing Water Line Kit

STEP 1
Locate the cold water source
STEP 1
To confirm you are using the cold water please shut off the water source valve and turn on your cold water
faucet. No water should come out.
STEP 2
Confirm Your Water Source Is Off
STEP 1
Drain the water from the faucet by turning on the hot and cold faucets until no water is running
STEP 2
Installing Water Line Kit
STEP 1
Run tubing from water source to cooler. If water source is located in a cabinet then you will need to drill a
small 3/8 inch hole into the front corner to run the tubing underneath the cabinet.
STEP 7
STEP 2
Use the Water Line Kit clips to affix the tubing underneath the cabinet alongside kick plate, or along wall to
help keep out of sight.
STEP 8
STEP 3
Determine if you have excess waterline running from you water source , and if so cut the poly tubing to the
correct length
STEP 9
STEP 4
Connect the two sided quick connect to the water line running out of the bottom back corner of you water
cooler.
STEP 10
STEP 5
Connect the tubing into the two sided quick connect provide in the waterline kit.
STEP 11
STEP 6
Once the water lines are connected, turn the water source back on and check for leaks. You might here a
filling noise from the cooler, but this is temporary, and will not occur often.
You will need to periodically check your water line, and all connections for leaks.
STEP 11
A water source looks like this. It can be typically found underneath the closest sink to were you would like to
place your cooler
Make sure that the water source you will work with is connected to the cold faucet on you sink by a water line
hose. The cold faucet can be determining which faucet is the cold faucet and connecting to that water line
hose
Turn the valve clockwise to shut of the water
Unscrew the cold water line hose from the shut off valve (you will have a few ounces of water remaining in
the hose that will drip out)
Attach the angle stop to the shut off valve, if the fittings connect correctly skip the next step
If the fittings do not connect then you most likely have a 3/8 inch fitting and will need the required adapter
To use the adapter simply screw the adapter into the end of the angle stop that will connect to the water
source hose
Attach the cold water line hose to the angle stop
Insert water line kit tubing into quick connect on angle stop
When finished with the above steps you should have tubing running from the angle stop
that is attached to the water shut off valve(water source) to the filter. Then tubing from the filter into the cooler.
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES