Aquverse 5ph - Water Leak and Cooler Cleaning; Water Is Leaking; Cleaning Your Water Cooler

STEP 1
Turn the cooler around so you are facing the back (wire caged portion) of the cooler
STEP 4
STEP 2
Locate the hot tank through the back cage, and then locate the hot tank reset button on the right side of
the hot tank
STEP 5
STEP 3
Using a chopstick or screwdriver, depress the hot tank reset button (water should be hot in 30 minutes
time, see figure below which pictures hole used to access hot tank reset button)
STEP 6
Water Is Leaking
STEP 1
If leaking is occurring from the nozzle of the faucets please contact customer service at 1-866-872-5722 for
replacement
STEP 3
STEP 2
If the leak is internal, please contact customer service at 1-866-872-5722
STEP 4
STEP 1
Fill the cold water tank with approximately four glasses of water
STEP 9
STEP 2
Drain this water through the cooler by opening the cold water faucet
STEP 10
STEP 3
Fill the cold water tank again with approximately four glasses of water
STEP 11
STEP 4
Drain this water through the cooler by opening the hot water faucet (this may take more time then through
the cold water faucet as done previously)
STEP 12
STEP 5
Insert the cleaned baffle back into the cold water tank
STEP 13
STEP 6
Install the magnetic float valve back to its original placement as noted before
STEP 14
Reset the hot tank by first unplugging the water cooler, then proceed to the next steps
Identify the source of the leak (i.e. internal, faucets, or top)
If hot tank switch is on then you will need to reset the hot tank (this can be tripped to the off position much
like a circuit breaker, if the cooler is plugged in before water is filled into the tank)
Remove the drain plug from the rear of the cooler (water will drain out of the cooler immediately, so you will
need a bucket or receptacle to catch the water
Check the back of the cooler, and make sure the hot tank switch is in the on position
Cleaning Your Water Cooler
If the faucets are the source of the leak, check to make sure the faucets have been screwed on completely. If
still leaking, drain the cooler of water and remove the faucets, and make sure the gaskets around the water
spigots are in good condition
Turn the water source off
Unplug cooler
Drain water out of the hot faucet until the water reaches room temperature (note that water is going to be
hot when you begin draining)
Remove top cover of cooler
Remove the magnetic float valve from the top of the cold water tank (not the position as you will need to re-
install when cleaning is completed)