Aquverse 1PH - Cooler Setup Guide; Initial Setup Steps; Attaching the Water Filter; Re-attaching the Front Cabinet

First Steps
Determine where your cooler is going to be located and place it close to the determined area This drinking water system must be maintained in accordance with the manufacture's instructions
DO NOT PLUG IN (see instructions that are provided with filter)
A professional licensed plumber can perform the install or you can obtain the following items at your local hardware store: Maximum PSI = 10-125 psi/Capacity = 1500 gallons/Temperature = 35-100 F
Attaching Filter Re-attaching Front Cabinet
STEP 1
Secure the filter into the filter cup to prevent movement
STEP 1
STEP 2
Slide the top cover back into position
STEP 2
STEP 3
Re-attach the screws to secure the top cover
STEP 3
STEP 4
Cooler Set Up
Filter Specifications
Remove the screws located at the top of the back of the water cooler
Lift upwards at the back of the top cover and pull towards you
Lift the filter assembly up so that you can access the filter
Attach filter to filter head by pushing in, and turning to the right until it
stops