Fill the cold water tank with approximately four glasses of water
Drain this water through the cooler by opening the cold water faucet
Fill the cold water tank again with approximately four glasses of water
Drain this water through the cooler by opening the hot water faucet
(this may take more time then through the cold water faucet as done
previously)
Insert the cleaned baffle back into the cold water tank
Install the float valve back to its original placement as noted before
Install the to cover of cooler back in its original position
Cleaning Your Water Cooler
Turn the water source off
Drain water out of the hot faucet until the water reaches room
temperature (note that water is going to be hot when you begin draining)
Remove top cover of cooler
Remove the float valve from the top of the cold water tank (note the
position as you will need to re-install when cleaning is completed)
Remove the drain plug from the bottom of the cooler (water will drain out
of the cooler immediately, so you will need a bucket or receptacle to
catch the water
Remove the baffle from the cooler and wipe down with a clean dish
towel, and water (do not use bleach or any cleaners, you may use a small
amount of soap if desired)
To Next Page
Loading...
