Aquverse 1PH - Water Source Identification and Preparation; Locate Cold Water Source; Confirm Water Source is Off

Locate Water Source Locate the cold water source
STEP 1
Make sure that the water source you will work with is connected to the
cold faucet on you sink by a water line hose.
STEP 1
Confirm Your Water Source Is Off
STEP 1
Drain the water from the faucet by turning on the hot and cold faucets
until no water is running
STEP 2
Turn the valve clockwise to shut of the water
A water source looks like this. It can be typically found underneath the
closest sink to were you would like to place your cooler
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES