7
Using the Aux In input
Use the audio cable included with this speaker to connect the
audio output from your device to the Aux In audio input on the
speaker’s back panel (you might need to open the rubber flap
protecting the jack). The speaker automatically switches to the
Aux In audio.
If you’re using a single speaker, the white Status light turns
on while you’re using the Aux In input. If you’re using two, the
blue Status light comes on and the stereo link with the other
speaker is turned off while you’re using the Aux In input.
Speaker back
To listen to Bluetooth audio again, unplug the cable from the
speaker’s Aux In jack.
IMPORTANT: The Aux In input plays your music on one speaker only. For
two-speaker stereo, you must use Bluetooth with two speakers linked for
stereo playback.
To Next Page
Loading...
