What to do if the RPM value is not displayed on ARAG Farm Equipment?
If the RPM value isn't showing on your ARAG Farm Equipment, it could be due to the computer not receiving signals from the RPM sensor. Check the connections to the RPM sensor. Also, consider that the RPM sensor might be wrongly installed, so check the connections to the RPM sensor.
How to fix inaccurate RPM readout on ARAG Farm Equipment?
An inaccurate RPM readout on your ARAG Farm Equipment may be due to a wrong setup. Check the setting of the constant for the RPM sensor.
Why is the output volume readout inaccurate in my ARAG Farm Equipment?
Inaccurate output volume readings in your ARAG Farm Equipment can stem from several setup issues. You should check the coverage setup and the row width. Also, verify the setup of the flowmeter constant, the wheel constant, and the type of section valves. Finally, inspect the connections to the speed sensor.
Why am I unable to reach output volume value set for the automatic operation on ARAG Farm Equipment?
If you're unable to reach the set output volume value for automatic operation on your ARAG Farm Equipment, several factors could be at play: * First, check the setup of the application rate and the row width. * Confirm the system is adequately sized to provide the required flowrate by checking the maximum pressure valve adjustment. * Ensure the control valve is adequate for the specific system and check the valve operation, as a control valve malfunction can also cause this issue.
How to calibrate the displayed tank level on ARAG Farm Equipment if it is not precise?
If the displayed tank level on your ARAG Farm Equipment is not precise, it might be due to the level sensor. Perform the calibration, and if that doesn't work, calibrate the level sensor again. Also, check the connections to the level sensor, as incorrect installation could be the cause.
Why is the sprayed fluid count displayed does not match liters/gpm actually sprayed on ARAG Farm Equipment?
If the sprayed fluid count displayed on your ARAG Farm Equipment doesn't match the actual liters/gpm sprayed, this might be caused by a wrong setup. Verify the setup of the flowmeter constant and the setup of the type of section valves.
What to do if the display no longer shows the speed on ARAG Farm Equipment?
If your ARAG Farm Equipment display stops showing the speed, it could be due to a wrong setup. Check the setup of the wheel constant. Alternatively, there might be no signal coming from the speed sensor, so check the connections to the speed sensor.
How to fix inaccurate instantaneous pressure readout on ARAG Farm Equipment?
An inaccurate instantaneous pressure readout on your ARAG Farm Equipment may be due to setup or installation issues. Verify the setup of the full scale for the pressure sensor. Also, check the connections to the pressure sensor, as incorrect installation could be the cause.
Why is the covered area count displayed does not match actual distance covered on ARAG Farm Equipment?
If the covered area count displayed on your ARAG Farm Equipment does not match the actual distance covered, it could be caused by a wrong setup. You should check the row width, the setup of the wheel constant, and the connections to the speed sensor.
Why is the distance traveled count displayed does not match actual distance covered on ARAG Farm Equipment?
If the distance traveled count displayed on your ARAG Farm Equipment doesn't match the actual distance covered, it might be due to a wrong setup. You should check the setup of the wheel constant and the connections to the speed sensor.
General| Display Type | LCD |
|---|---|
| Category | Control Systems |
| Display | LCD |
| Operating Voltage | 12 VDC |
| Housing Material | Plastic |
To Next Page
