Why does the sprayed fluid count displayed not match litres/gpm actually sprayed on ARAG Control Unit?
If the sprayed fluid count displayed on your ARAG Control Unit does not match the litres/gpm actually sprayed, check the setup of the folwmeter constant and the setup of the section valve type.
Why does the time count displayed not match actual time worked on ARAG IBX100 4679004?
If the time count displayed on your ARAG Control Unit does not match the actual time worked, it is because the work time count has not been reset. Reset the counter.
What to do if one valve does not open on ARAG Control Unit?
If one valve does not open on your ARAG Control Unit, it could be due to no power supply to the valve. Check the valve electric connection and operation.
Why do the valve controls take no effect on my ARAG IBX100 4679004?
If the valve controls on your ARAG Control Unit have no effect, it might be because the valves are not connected. Connect the IN-CAB cable and the connection cable to the valves.
General| Manufacturer | ARAG |
|---|---|
| Part Number | 4679004 |
| Model | IBX100 |
| Product Type | Control Unit |
| Voltage | 12 VDC |
| Protection Class | IP65 |
Details system components and cable selection for correct connection.
Instructions for securely mounting the control unit on the machine.
Introduces wiring connections for the system.
Securely fasten the ECU using specified bolts and orientation.
Provides the physical dimensions of the control unit.
Illustrates connection points for the sprayer unit.
Shows wiring for hydraulic systems with Seletron.
Use ARAG cables, avoid damage, and ensure correct connections.
Route cables to protect from water and damage.
Connect wiring harnesses to the control unit sockets.
Route and secure Seletron cables to prevent damage and ensure proper operation.
Guidelines for using extension cables for Seletron units.
Position components and route cables considering machine movement.
Connect valves for systems with section valves, ensuring proper seals.
Connect hydraulic valves according to initials and ensure proper seating.
Calibrate the pressure sensor to zero if an offset is detected.
Set the tank level sensor to zero when the tank is empty.
Calibrate the tank profile, ensuring the tank is full of clean water.
Configure alarms for rate, tank levels, and flowmeter status.
Set alarms for nozzle pressure, regulation, and RPM limits.
Enable alarms for Seletron status and ECU hardware faults.
Monitor the connection status of individual Seletron units.
Display progress during Seletron pairing procedure.
Diagnose connection status of individual Seletron units.
Color legend for Seletron status and troubleshooting diagnostics.
Sequence for connecting "Buffer zone" Seletrons.
Sequence for connecting "Fence" Seletrons.
Procedure to reset Seletron IDs before re-pairing.
Safety and setting preparation before replacing Seletrons.
Steps for disconnecting and connecting Seletron devices during replacement.
Lists error messages, their causes, remedies, and job modes.
Troubleshooting steps for valve control, speed display, and output accuracy.
Troubleshooting steps for sensor signals, RPM display, and connections.
To Next Page
