Revision Date – 22/12/2014 page 64
Remove the compressor mounting base the from
fridge.
Remove 2 rubber feet from compressor mounting
base. Retain both the rubber feet and the
fastening bolts.
Discard old compressor mounting base.
Fit the 2 rubber feet to the new compressor
mounting base using the original fasteners.
Fit the compressor, condenser and fan to the new
mounting base using the original fasteners.
Fit the new mounting base (complete with
compressor, condenser and fan) to the body of
the fridge.
Fasten the mounting base using the 10 original
fasteners.
Refit the rear cover.
CAUTION: When refitting the rear cover,
ensure that all cables are securely
fastened away from sharp, moving
or hot surfaces.
To Next Page
Loading...
