How to fix battery protection cut-out on ARB 60L?
To address the battery protection cut-out issue (indicated by 1 flash every 5 seconds) on your ARB Refrigerator, ensure that the correct battery protection setting has been selected to suit your requirements. Also, verify that the vehicle wiring is adequate, all terminals and joints are clean and in good condition, and the battery voltage at the socket is above the set cut-out voltage.
Why is the interior light not working in my ARB Refrigerator?
If your ARB Refrigerator's interior cabinet light does not work, it could be due to several reasons. The interior light globe may have blown, so replace it. There might be no power to the fridge, so ensure that either 12/24V DC or 100-240V AC power is being supplied. A faulty main circuit board or light switch could also be the cause, requiring testing and potential replacement of the circuit board or cabinet assembly.
Why is the lid of my ARB 60L Refrigerator hard to open?
If the lid of your ARB Refrigerator is hard to release from the body, the hinge assembly may have become contaminated with dirt. Carefully remove the lid, clean any dirt or grit from the hinge sockets, and service the hinge assembly.
What to do if my ARB Refrigerator has no power with 12/24V DC and the light doesn't work?
If your ARB Refrigerator is not getting power from a 12/24V DC supply and the interior light isn't working, there could be several reasons. It could be a blown interior light globe, a blown 12/24V DC plug fuse (which should be replaced with a T8 Amp 32V fuse), a fault with the 12/24V DC fridge power lead (check and replace if necessary), a poor connection of the plug to the socket, no power to the supply socket, the DC supply voltage being too low, incorrect polarity of the fridge power circuit, or a poor electrical connection inside the fridge. Check each of these to resolve the issue.
What to do for fan over-current cut-out on ARB Refrigerator?
To address a fan over-current cut-out (indicated by 2 flashes every 5 seconds) on your ARB Refrigerator, check that the fan is not obstructed or dirty.
How to resolve thermal cut-out on ARB 60L Refrigerator?
To address the thermal cut-out of the electronic unit (indicated by 5 flashes every 5 seconds) on your ARB Refrigerator, ensure adequate ventilation around the control unit and the compressor. Check that the fan is operating correctly, as it must always be running when the compressor is running. Also, try to improve ventilation around the fridge freezer or shield it from direct sunlight.
Why is the latch on my ARB 60L Refrigerator hard to disengage?
If the latch on your ARB Refrigerator does not easily disengage from the lid, it could be due to the high-quality seal causing the lid to sit away from the fridge cabinet; press down slightly on the lid to help disengage the latch. Alternatively, the latch itself may be faulty; inspect the latch and latch pivot for damage, and replace the latch assembly if necessary.
Why does the lid of my ARB 60L open while driving?
If your ARB Refrigerator's lid opens during transit, first, ensure that the latch was correctly closed before transportation. If the issue persists, inspect the latch and latch pivot for damage, and replace the latch assembly if necessary, as the latch may be faulty.
Why does the device fuse in my ARB 60L keep blowing?
If your ARB Refrigerator's device fuse repeatedly blows, it could be due to a short circuit in the 100-240V AC fridge cable. Check the cable's continuity and replace it if it's faulty or damaged. Another cause could be a short circuit between the "L" and "N" terminals on the compressor control unit; check for this. Lastly, an unregulated or fluctuating power supply, such as from an engine-driven generator, might be the issue. Ensure the generator has a voltage regulator and supplies a standard, pure sine wave AC voltage without fluctuations.
What to do if I can't change the temperature on my ARB 60L?
If your ARB Refrigerator runs but you cannot change the target temperature, the control panel circuit board may be faulty. To resolve this, test the fridge with a new control panel circuit board, and replace it if the issue is resolved.
Details the terms, conditions, and exclusions of the limited warranty.
Explains troubleshooting by interpreting diagnostic error light flash codes.
Guides on diagnosing issues related to 12/24V DC power input to the fridge.
Provides troubleshooting steps for problems with 100-240V AC power supply.
Addresses issues related to the fridge not cooling or cooling incorrectly.
Explains the three battery protection modes and how to adjust them.
A flowchart to diagnose why the fridge won't run on AC power.
A flowchart to diagnose why the fridge won't run on DC power.
Details how to test the vehicle's wiring system for voltage drop.
Procedure to test the compressor control unit's operation on DC power.
Procedure for testing the main circuit board's AC power section.
Procedure to test the compressor control unit's operation on AC power.
Tests the internal compressor windings for resistance.
Details how to test the thermistor's resistance value.
Step-by-step instructions for replacing the control panel circuit board.
Procedure for replacing the compressor control unit.
General| Brand | ARB |
|---|---|
| Model | 60L |
| Category | Refrigerator |
| Language | English |
To Next Page
