20/EN
Replacing the oven lamp
Before replacing the oven lamp, make sure
that the product is disconnected from mains
and cooled down in order to avoid the risk of
an electrical shock.
Hot surfaces may cause burns!
The oven lamp is a special electric light bulb
that can resist up to 300 °C. See Technical
specifications, page 5 for details. Oven lamps
can be obtained from Authorised Service
Agents or technician with licence.
Position of lamp might vary from the figure.
The lamp used in this appliance is not suitable
for household room illumination. The intended
purpose of this lamp is to assist the user to
see foodstuffs.
The lamps used in this appliance have to
withstand extreme physical conditions such as
temperatures above 50 °C.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to remove
it.
3. If your oven lamp is of type (A) shown in the figure
below, remove it by rotating as shown and replace
it. If it is of type (B), pull and remove it as shown
in the figure and replace it.
4. Install the glass cover.
To Next Page
Loading...
General