CONFIDENTIAL
15
30” BUILT-IN REFRIGERATOR / REVISION NUMBER: 00
4. PRODUCT USE
ವ Adequate distance must be left on the bottom, up, right and left of where the refrigerator is
located to ensure air circulation.
• In products with water fountain, the water inlet of the refrigerator is behind it so the hose
installed must be prevented from breaking or crushing.
• If the refrigerator has a mains-fed ice maker, enough space must be set for mains system.
• Plug your refrigerator only to grounded sockets. Ensure that the power cord is not damaged
during transportation.
• Do not have radiator, heater etc. devices near the refrigerator.
• The point where the refrigerator is placed shall be at a proper distance for mains connection.
• Do not expose the refrigerator to direct sunlight.
• Have the level adjustment performed as per the installation position of the refrigerator.
• Suitable space must be provided for the refrigerator doors to open easily.
• The position of the refrigerator must be suitable for service and maintenance.
• Do not use the refrigerator in locations with wet floor.
There is a risk of electrical shock regarding
safety.
5. GENERAL OPERATION PRINCIPLE
The 30” electronic refrigerator consists of cooling and freezing compartments. It is a microprocessor
controlled no-frost refrigerator. Thanks to the microprocessor, all functions and temperature controls are
performed as per the request of the user. The firmware inside the microprocessor controls the cooling
and water system elements (compressor, fans, heaters, valves, ice machine, solenoids, ice breaking
motor and ionizer etc.).
The refrigerator cools by continues passage of the air in the refrigerator by the
fan over the evaporators, and its circulation separately for the Freezer and FF.
Frost deposit and icing similar to the situation with the conventional refrigerators is not formed within the
usage areas of No-Frost refrigerator. The frost deposit occurring on the evaporator, which is outside the
usage area, is melted by the heaters automatically engaged by the microprocessor in intervals
determined by the control algorithm.
Thus, the frost and ice accumulating on the evaporator is melted
without any intervention by the user, and the refrigerator runs more efficiently.
To Next Page
Loading...
Need help?
General
