35
ATV-0016
ATV-0026
ATV-0027
1. Keep your speed way down; less than 5
mph.
2. Approach the obstacle head-on.
3. Come up off the seat.
4. Keep your weight on the footrests.
5. Apply a little throttle when the front
tires make contact with the obstacle.
6. Lean forward and release the throttle
when the front tires clear the obstacle.
7. Keep your body loose to absorb any
shock.
8. If the ATV starts tipping, shift your
weight to keep it in balance.
To clear a single-track (only one tire contact-
ing) obstacle, follow the same rules except:
1. Use the ATV’s momentum to clear the
obstacle.
2. Don’t pull up on the handlebar.
3. Don’t apply the throttle.
Driving an ATV and a car have some
similarities; however, there are a few sit-
uations that require special attention:
• Reversing
• Skidding or Sliding
• Parking on a Hill
• Stalling on a Hill
•Crossing Water
• Crossing Roads
• Stopping the ATV
• Stopping the Engine
Reversing
It’s tough to see things behind you.
1. Go slowly. It’s hard to see behind
you.
2. Keep your handlebar straight.
3. Backing down hills is a bad idea; do
a U-turn or K-turn instead to turn
around.
Skidding or Sliding
If you lose control after hitting sand, ice,
mud, or water:
1. Turn your handlebar into the direc-
tion of the slide.
2. Keep your hand off the brakes until
you’re out of the skid.
3. Shift your weight forward.
Sometimes your ATV may not respond
and goes straight ahead instead of letting
you turn. Here’s how to handle it:
1. Slow down.
2. Move forward on the seat.
3. Lean to inside of turn.
4. Turn handlebar.
Parking on a Hill
This shouldn’t be necessary, but if it is:
1. Keep it in gear.
Tips
! WARNING
Never activate the override while the
throttle is open as a loss of control
may result. Use caution when using
the override switch as reverse speed
can greatly increase.
To Next Page
Loading...
