EasyManua.ls Logo

Arctic Cat 300 - General Maintenance; Maintenance Schedule Overview

Arctic Cat 300
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Recommended
Transmission/Rear Drive
Lubricant
NOTE: Arctic Cat recommends
the use of genuine Arctic Cat lubri-
cants.
The recommended lubricant (transmis-
sion and rear drive) is SAE approved
80W-90 hypoid. This lubricant meets all
of the lubrication requirements of the
Arctic Cat ATV.
Engine Break-In
After the completion of the break-in
period, the engine oil should be changed
and the screen should be cleaned. Other
maintenance after break-in should
include checking of all prescribed adjust-
ments and tightening of all fasteners. At
the discretion and expense of the owner/
operator, the ATV may be taken to an
authorized Arctic Cat ATV dealer for this
initial service.
New ATV’s and renewed ATV engines
require a “break-in” period. The first
month is most critical to the life of this
ATV. Proper operation during this break-
in period will help assure maximum life
and performance from the ATV.
During the first 10 hours of operation,
always use less than ½ throttle. Varying
the engine RPM during the break-in
period allows the components to “load”
(aiding the engine/transmission compo-
nent mating process) and then “unload”
(allowing components to cool). Although
it is essential to place some stress on the
engine components during break-in, care
should be taken not to overload the
engine too often.
When the engine starts, allow it to warm
up properly. Idle the engine several min-
utes until the engine has reached normal
operating temperature. Do not idle the
engine for excessively long periods of
time.
Burnishing Brake Pads
Brake pads must be burnished to achieve
full braking effectiveness. Braking dis-
tance will be extended until brake pads
are properly burnished.
To properly burnish the brakes, use fol-
lowing procedure:
1. Choose an area sufficiently large to
safely accelerate ATV to 30 mph and
to brake to a stop.
2. Accelerate to 30 mph; then com-
press brake lever to decelerate to 0-5
mph.
3. Repeat procedure twenty times.
CAUTION
Any lubricant used in place of the
recommended lubricant could cause
serious transmission or rear drive
damage.
! WARNING
Do not attempt sudden stops or put
yourself into a situation where a sud-
den stop will be required until the
brake pads are properly burnished.

Table of Contents

Related product manuals