ARDETEM DIP 506 - 4.4 Programming menu; 4.4.1 Input programming

p6
M
InPut
InPut
4.4 Programming menu
(according to options)
dISPL.
OUt.MA
OUt.U
JbuS
tor
rELAY
SECU
Pr.diS
SAvE
SAvE
Access to the input programming
p6
Access to the scale factor programming
p7
Access to the analog output programming
p7
(option analog output)
Access to the communication parameters (RS485)
p8
(option digital output)
Access to the programming of the LOGIC inputs
p8
(option LOGIC inputs)
Access to the programming of the relays (2 or 4 relays)
p8
(option relay output)
Access to the programming of the output and the relays
p9
in case of self-diagnosis error
(option analog or relay output)
Access to the display programming:
p9
Leds, Bargraph, Display brightness
Access to the instrument configuration menu
p10
Access to the programming exit menu, with or
p11
without configuration saving
Note
:
⇒
Press key to revert to the menu
⇒ In mode programming, the instrument will automatically resume
measure with the previous configuration if no key is pressed during
1min.
M
diSPL.
Note
:
Press key to revert to menu
SEt.CF
or
M
Note
:
Press key to go on to next menu
Move through menus / choice
Upwards move / increase
Validation / vertical move
Downwards move /
decrease
Exit / menu access
M
4.4.1
Programming of the process
signals input
caliber choice
down scale
-110.0 < x < 110.0 (mV)
Note
: For the entering of the
down and full scale and the
linearisation points, (value in
mV), the decimal point must
be adjusted after
programming the 4th digit.
For the automatic setting
see
page 19.
If special linearisation
enter the number of points
from 1 to 18
special linear
functions
«
«
d.in
«
00.00
diSPL.
10.00
100.0
20.00
50.00
«
nb
«
0018
«
A01
«
00.00
«
A18
(1)
(1)
(1)
full scale
«
F.in
«
100.0
(1)
(1)
«
«
«
«
CALib
«
Li.SPE
«
Funct.
«
00.00
InPut
linear
functions
«
LinEA.
(1)
If special courve