13
461306186 (A-000)
GB
3. USER INSTRUCTIONS
CLEANING AND MAINTENANCE
Prior to any maintenance work or cleaning, disconnect
the appliance from the electricity mains.
Do not use a steam cleaner to clean this appliance.
EXTERIOR PARTS
All the parts of the oven exterior (stainless steel, side
panels, door glass) must be cleaned frequently with a
mild detergent and a little water and then dried with a
soft cloth.
Do not wash the parts if they are still hot and never use
abrasive powders, pads or corrosive spray products.
Do not leave vinegar, coffee, milk, salty water or the
juice of lemon or tomato on the surface for any length
of time On painted or stainless steel surfaces, do not
use aromatic or aliphatic solvents to remove spots or
label adhesive.
INTERIOR PARTS
The oven should be cleaned after each use to
remove cooking residuals like fats or sugar which,
burnt afterwards, can encrust or form permanent
stains and unpleasant smells.
The oven should always be cleaned when it is still
warm with soapy water, rinsed and dry properly on
all surfaces. Never use abrasive powder cleaners or
sponges. Also wash any accessory used.
Do not leave ingredients like vinegar, coffee, milk,
salty water, lemon juice or tomato sauce on enamelled
surfaces for a long time.
Do not spray or wash the electric heating
elements nor the thermostat with acid-based
detergents (check the information label on the
product you are using). The manufacturer cannot
be held responsible for any damages caused by
incorrect cleaning.
OVEN SEAL
The condition of the oven seal is vital for the correct
functioning and performance of the oven.
We recommend you:
• Clean it, avoiding abrasive tools or products.
• Check its condition occasionally.
In case the seal has stiffened or presents
damages, contact your nearest Service centre
and avoid using the oven until it has been
repaired.
CHANGING THE OVEN LAMP (fi g. 7)
Attention!! Before replacing the oven light,
disconnect the appliance from the electricity
supplies.
If the oven lamp (L) has to be changed the new lamp
must have the characteristics indicated on page 14
and resistant to high temperatures (300°C). Turn glass
protection cap (C) counterclockwise and change the
lamp. Put the cap back on taking care to insert the
notches in the locking tangs and turn clockwise.
4. TROUBLESHOOTING
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Engineer please check the following chart.
PROBLEM occurring SOLUTION envisaged
The oven does not work • Check that the plug is connected.
• Check that the programmer / clock is set for manual operation.
• Check the electrical system (fuse electricity board). If there is failure
in the system call an electrician.
During cooking the thermostat led
does not turn back on
• Turn the thermostat round to a hotter temperature.
• Turn the selector round to a different function.
The oven light does not switch on • Turn the selector round to a different function
• Check that the oven bulb is properly fi tted
• If it has blown, buy a bulb specifi cally for high temperatures at a
Service Centre and fi t it following the instructions given on page 13..
To Next Page
Loading...
