Enter your new password again to verify it and
then press #.
NOTE: If you hear a long beep and see blue light,
the entry is successful! Two short beeps and red
light means entry has failed. Repeat if it fails.
___ ___ ___ ___
ADD THE FIRST FINGERPRINT (ADMINISTRATOR)
IMPORTANT NOTES:
⦁ You can add up to 100 fingerprints into the door lock. Each user is given a User ID
number
from 0 to 99
⦁ Selecting User ID number 0, 1 or 2 for a user will make them an Administrator.
⦁ Administrators can enter setup (login) by just using their fingerprint (no Programming
Code entry required)
To start door lock setup, press *
Enter the Programming Code
(password) that you chose (or default
code 1234) and then #
___ ___ ___ ___
To add a fingerprint, press 1 and then *
Choose the User ID number for the first
fingerprint (Administrator is 0-2) and then
press #
2
To Next Page
Loading...