30
Degrease the pin and the
special nut for the pole's drive
lever with solvent
(See § 2.6).
For the leading" pole,
reposition the drive lever plate
and refit the two bolts (ratchet
wrench + 10 mm open-ended
spanner).
Apply a film of thread lock over
all of the threading on the pin
whilst taking care to hold it by
its smooth part (without
touching the threading).
C
262
In order to obtain a high
quality bonding, this operation
must be carried out at an ambient
temperature higher than +15°C.
During maintenance, it is
forbidden to retighten the
nuts marked with red nail
varnish.
Leading" pole: Fit the pin and the shoulder nut. Tighten
to the indicated torque (19 mm open-ended spanners,
torque wrench with a 17 mm socket).
Led" pole: Fit the pin, the washer and the nut. Tighten to
the indicated torque (17 mm open-ended spanner, torque
wrench with a 17 mm socket).
Leading" pole Led" pole
3.5 3.5
To Next Page
Loading...
