Argo HERMES PLUS - Temperature Display and Error Codes; Smart Life App and Wi-Fi Connection; App Usage Prerequisites; Wi-Fi Connection Methods

38V 01/24
TEMPERATURE DISPLAY AND ERRORS
With the exception of message P1, tank full, when an error occurs do not attempt to repair the air conditioner,
always take it to an Argoclima Assistance Centre, otherwise the guarantee will no longer be valid.
Problem Cause Solution
00/E0
Communication faults between main PCB
and display PCB.
Contact a service centre.
E1 Failure of room temperature sensor. Contact a service centre.
E2
Failure of temperature sensor on the
evaporator.
Contact a service centre.
Ft Alarm of full water tank.
Connect the PVC pipe to the condensate
drain hole.
INFORMATION ON THE “SMART LIFE” APP
The “Smart Life” App is available for Android and iOS. Scan the corresponding QR code to directly access the
download.
INFORMATION ON USING THE APP
• The presence of an integrated wi module allows you to manage the functions of the device via the home network.
• The prerequisites are a permanent Wi-Fi connection to the home modem and the free “Smart Life” app.
• Download and install the “Smart Life” App on your smartphone or tablet. Create your account and log in
• Activate the WIFI function on the device.
• Place the device at a distance of approximately 5 meters from the router.
• Long press the Timer button to start the network setup, when the WIFI indicator ashes, you can connect the WIFI
WIFI CONNECTION
It is possible to follow 2 methods to connect the device to WiFi.
METHOD 1: CONNECT VIA BLUETOOTH
• Activate Bluetooth on your cell phone or other device.
• When the WIFI indicator ashes, open the “Smart Life” APP, the unit will be automatically connected via Bluetooth.
METHOD 2: CONNECTION VIA APP
• When the WIFI indicator ashes, select Add device / Large appliances / Portable air conditioners and follow
the instructions on the display.
• Check the status of the WIFI indicator and choose the correct status.
• If the Wi indicator ashes quickly, you can connect directly.
• If the WIFI indicator ashes slowly, press “Go to connection” to connect the wi named “SmartLife-XXXX”
Remarks: Once the appliance has been correctly connected, the WIFI indicator lights up. Now you can use the
appliance via the App. Press and hold the Timer button for about 5 seconds, the device disconnects, the WIFI indicator
turns off.
WIFI GUIDE
Smart Life App download