30V 01/23
BY REMOTE CONTROLLER
How to insert the battery into the remote controller
Open the battery door on the back of the remote controller by pressing the back and pulling the door (1). Place the
battery in the door, taking care to check that the polarities are positioned correctly. Insert the door into the remote
controller. (2).
Use a Lithium/Manganese button cell, model no. CR2025 -3 V (supplied), compliant with Battery Directive no.
2006/66/EC and amendments by Directive 56/2013/EU.
Do not use new batteries with dead batteries. If the remote controller is not used for a long time, remove the battery.
Make sure you dispose of the battery properly.
WARNINGS FOR BATTERIES
• Batteries should not be exposed to heat sources such as re, sun or similar sources;
• remove the batteries if they start to heat up or you know you will not use the appliance for a long time the batteries
must be installed correctly in the battery compartment;
• when removing the batteries because they are at the end of their life or damaged, comply with the national
regulations in force for disposal (shown below);
• In the event of a battery uid leak, remove all batteries, taking care not to let the leaked uid come into contact
with skin or clothes.
FUNCTION CONTROLS
Continuous drainage
(Dehumidifying)
Manual drainage
(Cooling and Heating)
2
Dehumidication
Warning: when using the air conditioner in dehumidication mode, it is advisable to always arrange for continuous
drainage, so as to maximise dehumidication efciency. Connect one end of the supplied PVC pipe to the upper
discharge hole and place the other end above a drain.