34V 02/23
When the unit is on in COOL mode, set the time after which you want the unit to turn off.
Remote controller: press “TIMER” to set a time to turn off the unit. Press UP/DOWN to set the hour. The G icon
stays on and indicates that the OFF TIMER is on.
Air conditioner: Press TIMER repeatedly to select the hour from 1 to 24, once the desired hour has been reached,
wait for the display to stop ashing.
Canceling the timer: If a TIMER is set, press TIMER to view the set timer. Press TIMER again to cancel the set TIMER.
6. SWING BUTTON
Press this button on the control panel or remote controller to activate or deactivate the automatic swing of the air
aps.
7. UP/DOWN BUTTONS
The temperature adjustment range goes from 16° to 31°C.
Temperature increase UP:
1.Allows you to adjust the desired temperature in Cooling modes.
2. Each time the UP button is pressed, the set temperature increases by 1°C.
Decreasing temperature DOWN:
1.Allows you to adjust the desired temperature in Cooling modes.
2. Each time the (DOWN ) button is pressed, the set temperature decreases by 1°C.
The same button allows you to set the TIMER.
8. WIFI BUTTON
See paragraph dedicated to the Wi Guide.
9. WATER TANK FULL INDICATOR (Power Full)
If the water tank is full this LED indicator lights up on the control panel.
MEMORY FUNCTION
In the event of a blackout, when the power is restored the unit will resume operating according to the last settings,
except for the Automatic mode.
TEMPERATURE DISPLAY AND ERRORS
In the event of a malfunction, the display shows an error code, which facilitates the solution of the problem. With
the exception of the FL message, full tank, when an error occurs do not attempt to repair the air conditioner, always
take it to an Argoclima Assistance centre.
SECURITY FUNCTIONS
COMPRESSOR PROTECTION
It takes 3 minutes before it starts. When you turn off the unit, you cannot restart it before 3 minutes have passed
since the previous stop.
AUTOMATIC DEFROST
When it works in heating mode, there is a risk of ice forming on the coil: therefore the air conditioner stops to melt
the ice and then restarts.
Problem Cause Solution
E1 Room temperature sensor failure. Contact a service centre.
E2
Failure of temperature sensor on the
evaporator.
Contact a service centre.
FL Alarm of full water tank.
Connect the PVC pipe to the condensate
drain hole.
To Next Page
Loading...
Need help?
General
