29V 02/23
HOW TO USE THE APPLIANCE
This appliance can be used for Cooling, Heating, Dehumidication and Fan. Before using the appliance, leave it in
an upright position for at least two hours.
Plug the power cord into an appropriate power outlet (220-240~V). Insert the supplied battery into the remote
controller, observing the polarities. Select the desired operating mode from the remote controller.
The air conditioner is equipped with a protection system which causes the unit to activate in Cooling, Dehumidication
and Heating mode only after an interval of approximately 3 minutes from the selection. Even when passing from one
mode to another, the fan continues to operate, but the compressor stops to restart after 3 minutes. This start delay
protects the compressor from overload.
This appliance is equipped with an automatic defrosting system which intervenes when the unit is running hot and
ice forms on the coil. When the appliance starts defrosting, the Power Full LED ashes on the control panel. The
compressor stops for 10 minutes, after which the appliance resumes normal operation.
THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidication mode only, in which case the appliance should be left to discharge directly
into the room for maximum efciency (see the “Dehumidication Mode” paragraph).
Clean the air ltes under the easily removable side grille regularly to keep the air conditioner working efciently.
Cooling, Heating, Fan
Dehumidifying
Avoid tight bends or folds in the hose.
If the air conditioner is not used for prolonged periods, disconnect the pipe and plug the window unit.
To Next Page
Loading...
Need help?
General
