16
V 06/18
WARNING:
THE ON/OFF SWITCH IS NOT THE ONLY METHOD OF
DISCONNECTING THE MAINS POWER.
ALWAYS UNPLUG THE APPLIANCE DURING MAINTENANCE
OPERATIONS, WHEN MOVING IT OR WHILE IT IS NOT IN USE.
A fan heater contains parts that generate electrical arcs and sparks.
It must not be used in potentially dangerous areas such as those
subject to the risk of fire or explosion, or areas filled with chemical
substances or humidity.
Always unplug the appliance when it is not in use.
Turn the appliance off if unattended, in order to prevent accidents.
In the event of any anomalies (abnormal noise or a strange smell),
immediately turn off the appliance; do not attempt to repair it but
take it to your local service centre.
DESCRIPTION OF PARTS
7. Remote control
1. Air suction grille
2. LED display
3. Air output grille
4. Horizontal flap
5. TIMER button
6. Function selection F button
HOW TO INSTALL THE FAN HEATER
The fan heater must be installed on the wall before use. Do not try to use it without installation. The installation sequence is
listed below:
1. Select a space for installing the appliance (figure 1).
2. Drill two holes on the wall that are suitably sized for inserting the Ø 8 mm Fischer screw plugs. (figure 2) – D=575 mm
To Next Page
Loading...
Need help?
General
