NITROGEN : 7. Seatpost installation
21
7.1 Peel o the plastic of the double-
sided tape located at the back of the
seat clamp wedge (11).
7.2 Place the seat clamp wedge
(11+12) inside the frame.
7.3 Insert the seatpost (3) on which
some carbon ber assembly gel has
been applied.
7.4 Position the seatpost to the desired
height.
7.5 Tighten the set screw at max. 5.5Nm
while leaving a space between the two
parts allowing them to slide.
GREASE
GREASE
THREADLOCKER
BLUE (n. 242)
LOCTITE
GREASE
CARBON FIBER
ASSEMBLY
COMPOSITE
5.5 Nm
1Nm
1.4
To Next Page
Loading...
