2. INSTALLATION ON WINDOWS OPERATING SYSTEMS
• Before installing the Passport Reader software, all previous versions of the software have to
be uninstalled from the system. This process differs depending on the version that is currently
installed on the system.
- For versions 2.1.5-26W or earlier, go to Start Menu / Programs / GX / UNINSTALL and
run – FULL UNINSTALL – as well as Start menu / Programs / GX / 32 bit version /
– FULL UNINSTALL – if applicable.
- For versions 2.1.6 or later, go to Control Panel / Add/Remove Programs and remove
all versions of the Passport Reader software.
• Once all previous versions of the software have been uninstalled, restart the computer.
Upon installation of the 32-bit version to a 64-bit PC, the 64-bit device drivers are
installed automatically. For 32-bit application development on 64-bit PCs, install the
32-bit version of the Passport Reader software as well.
To Next Page
Loading...
