INSTALLING THE HARDWARE
ADJUST THE BRACKET
1. Loosen the camera fastening screw on the bottom of the bracket. (Use a size 5 Allen key).
2. Adjust the bracket into the desired position.
3. Tighten the screw back.
1. MOUNTING
The bracket can be mounted on different surfaces. Use appropriate screws for installation, the
surface on which the camera will be mounted determines what screws should be used.
Remove protective film from the protecting plate (on the front of the camera) before
using the FreewayCAM.
Do not overtighten the screws.
Damages resulting from inappropriate installation void the warranty.
To Next Page
Loading...