ARI D-040 User Manual

15
IOM D-040
5.3.4. Cleaning and inspecting the components
• Thoroughly but gently wash and clean all the components under clean running water. Pay attention to the sealing
area inside the Body.
• Visually check the condition of the Rolling Seal [1] & [2]. If any cracks or tears are found remove it from the Float
and replace it.
• If replacement is necessary, slide out and remove the Rolling Seal Assembly [3]
• Take a new Rolling Seal Assembly and dip the tail end into the liquid soap solution [4]
1
2
3
4

ARI D-040 Specifications

General

Brand	ARI
Model	D-040
Category	Control Unit
Language	English