Ariens 72407100 User Manual

© Copyright 2009 • Ariens Company • Brillion, WI 54110-1072 00361400A 8/09 Page 1 of 2
Instruction Sheet
Kit Number: 72407100, 72408100
SNOW CLEAN-OUT TOOL KIT
Package Contents
Check the contents of your kit for the parts listed below
(Figure 1):
TOOLS NEEDED
3/8" Wrench
Slotted Screwdriver
3/16" Drill Bit
INSTALLATION
1. Stop engine, wait for all moving parts to stop and
hot parts to cool. Disconnect spark plug wire from
spark plug.
2. Use the snow clean-out tool mount (item 2) as a
template to lay out two mounting holes on the top of
the auger housing. See Figure 2.
NOTE: Choose a location on the auger housing that will
not interfere with the operation of the unit and that will
prevent the snow clean-out tool (item 1) from hanging
over the sides or over the front of the auger housing.
3. Drill the two 3/16" mounting holes through the
auger housing.
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal injury
and/or damage to unit.
Read, understand, and follow all safety
practices in Owner/Operator Manual before
beginning.
ACCIDENTAL ENGINE START UP can cause
death or serious injury. ALWAYS stop engine,
remove key, wait for moving parts to stop, and
remove wire from spark plug before adjusting
or servicing.
Item Part No. Qty Description
1. 00170200
03901400
1
1
Snow Clean-Out Tool
(724071)
Snow Clean-Out Tool w/
Brush (724081)
2. 00170300 1 Snow Clean-Out Tool Mount
3. 06536000 2 10-24 Nylon Lock Nut with
Insert
4. 06117600 2 10-24 x 1/2 Round Head
Slotted Machine Screw
Figure 1
3
4
2
1 (724071)
1 (724081)
Figure 2
2

Ariens 72407100 Specifications

General

Engine Type	4-Cycle
Auger Material	Steel
Engine	Ariens AX
Start Type	Electric start
Clearing Width	24 in
Weight	178 lbs
Product Type	Snow blower
Tire Size	15 in x 5 in
Fuel Capacity	2.9 quarts
Fuel Tank Capacity	2.9 quarts

Summary

Tools Needed For Installation

Package Contents

Installation Procedure

Pre-Installation Safety Steps

Stop engine, wait for moving parts to stop, and disconnect spark plug wire before beginning.

Locating and Preparing Mounting Holes

Use mount as template for holes, consider location to avoid interference with unit operation.

Drilling Mounting Holes

Drill two 3/16" mounting holes through the auger housing.

Attaching the Clean-Out Tool Mount

Install mount using screws and nuts, ensuring nuts are on inside and not overtightened.

Operation: Clearing the Chute

Impeller Contact Safety Warning

Hand contact with rotating impeller is a common cause of injury; never use hand to clean chute.

Chute Clearing Steps

Steps to safely clear clogs using the clean-out tool and reconnecting the spark plug wire.