Ariens 927 Series User Manual

Safety Precautions
Operation
Keep equipment in good condition. Keep all
shields in place and safety oo operating
properly.
Operate unit only when there is good visibility
and light.
Disengage mower clutch (OUT) and make sure
Speed Selector is in neutral (N) position
before
attempting
to
start
engine.
l
Open doors if unit is run in garage, exhaust
-
fumes
contain
carbon
monoxide,
an
odorless
and
deadly
gas.
DO
NOT
run
engine
in
enclosed
or poorly ventilated areas.
Disengage mower.clutch when riding mower is
being operated in reverse, transported or is not
- in use. ;
Look behind and use cate when backing.
Someone may have come up behind you.
NEVER direct discharge of material toward
bystanders nor allow anyone near equipment
while unit is in operation. The operator is
responsible for the safety of bystanders.
Tipping and/or loss of control of unit can be
caused by; operating on slopes, rough terrain,
turns, speed changes, slippery surfaces, and
bagger load as well as any combination of
them. l
Be familiar with area of operation. Stay alert for
holes, rocks, roots and hidden hazards in area
of operation. Keep away from drop-offs.
Exercise extreme caution when operating on
or crossing gravel drives, walks or roads. Stay
alert for hazards and traffic.
DO NOT. stop or start suddenly when going
„uphill or downhill. Mow up and down face of
steep slopes: NEVER across face. If slope is
too steep to back riding mower up; slope is too
steep for safe operation. —
Reduce speed and exercise extreme caution
on slopes and in sharp turns to prevent tipping
or loss of control. Be especially cautious when
changing direction on slopes and operating on
wet or slippery surfaces.
Disengage mower clutch, stop engine, remove
key, wait for moving parts to stop before leav-
_ing operator’s position for any reason such as
unclogging discharge chute, when making any
repairs, adjustment, inspections or cleaning
unit. RE
Vf
DO NOT touch equipment parts which might.
be hot from operation. Before attempting to
maintain, adjust or service allow such EPERS to
cool. a
lf equipment vibrates abnormally, disengage
mower clutch, stop engine at once and remove
key. Abnormal vibration is a warning to trouble.
Repair any damage before restarting unit. (See
your Ariens Dealer.)
After striking a foreign object, disengage
mower clutch, stop engine.and wait for moving
parts to stop before leaving operator’s posi-
tion. Thoroughly inspect unit for any damage
and repair damage before restarting and
operating unit.
Use care when pulling loads or using grass col-
lector. Use only approved drawbar hitch points.
Limit loads to those you can safely control.
Take all possible precautions when leaving
unit unattended. Disengage mower clutch, '
lower attachment, engage parking brake, stop `
engine and remove key to prevent unauthoriz-
ed use.
Maintenance and Storage
DO NOT change engine governor setting. or
over speed engine.
Keep all nuts, bolts and screws tight and. be
sure equipment is in safe working condition.
Check all hardware at regular intervals.
To reduce fire hazard and overheating, keep
equipment free of grass, leaves, ic or: ex-
cessive grease.
Worn out mufflers s are more than just a noise
nulsance and should be replaced immediately.
Continued use could result in fire or explosion.
NEVER store equipment with gasoline in tank
inside a building where fumes may reach an
open flame or spark. Allow engine to cool
before storing in any enclosure.
Refer to Storage Section. of this Owner's
Manual for important instructions if unit is to
be stored for extended periods.

Ariens 927 Series Specifications

General

Brand	Ariens
Model	927 Series
Category	Lawn Mower
Language	English