Ariens 927 Series User Manual

Decals
[| CAUTION
. ¿++ Read operators manyal
e Keep shietds in place
e Keep propie and pets away
e Release parking brake
_ © Depress clutch pedal
@ Shift to ist or 2nd speed
e Slowly release clutch
e Shift to desired speed
e Depress clutch pedal
: © Depress Brake pedal
ñ © Belore leaving aperator's
‘ “position:
C
Shift to neutral
Engage parking brake
Oisengage mower clutch
Stop Engine
Remove ignition key
SERVICING |.
-e Waittor att movement to stop *
e. Disconnect spark plug wire i
+ Before tipping unit, drain 5
gas tank and remove
battery -—it electric
Manulactured Unges Pat Numbers 3.639.919 & 3 799.094
Before starting engine
be sure machine is'in
neutral and mower
clutch is disengaged.
Mower
Helght Low ©
Mower
Cluteh::
O
ROTATING
BLADE
«Keep hands
& feet away.
‘Stap engine &
remove ignition)
key before:
clearing.
Figure 1: Decal Location
Dealer Preparation for Operation
NOTE: All references to “Left”, “Right”,
- “Front” and “Rear” are given from operator's
position.
` Customer Note: Your Ariens Dealer is expected
to complete these preparation steps and
review. important information, including this
manual, with you before or upon delivery of
this unit. l
The preparation information is included here
so that you and your dealer may review it
together.
Steering Wheel
Place steering wheel onto column shaft
(lubricate shaft) with holes lined up and drive
roll pin through holes to secure. (Pin should
have equal spacing on both sides of steering
wheel base.) :
Seat (RM-928 & RM-1232)
Place seat on seat bracket and install four cap
screws with lock washers. Connect seat
switch wires to connectors. Slide seat to a
safe comfortable operating position and
tighten cap screws to secure seat in position.

Ariens 927 Series Specifications

General

Brand	Ariens
Model	927 Series
Category	Lawn Mower
Language	English