EN - 4
3. Danger!
EMISSION CONTROL SYSTEM
This equipment and/or its engine may include
exhaust and evaporative emissions control
system components required to meet U.S.
Environmental Protection Agency (EPA)
and/or California Air Resources Board
(CARB) regulations. Tampering with
emission controls and components by
unauthorized personnel may result in severe
fines or penalties. Emission controls and
components can only be adjusted by an
Ariens Company dealer or an authorized
engine manufacturer's service center.
Contact your Ariens Company equipment
retailer concerning emission controls and
component questions.
SAFETY RULES
Training
Read the instructions carefully. Be familiar
with the controls and the proper use of the
equipment.
Never allow children or people unfamiliar with
these instructions to use the edger. Local
regulations may restrict the age of the
operator.
Never edge while people, especially children,
or pets are nearby.
Keep in mind that the operator or user is
responsible for accidents or hazards
occurring to other people or their property.
Preparation
While edging, always wear eye and ear
protection, substantial foot wear, and long
trousers.
Thoroughly inspect the surface where the
equipment is to be used and remove all
stones, sticks, wires, bones and other foreign
objects.
Replace faulty silencers.
Before using, always visually inspect to see
that the blades, blade bolts and cutter
assembly are not worn or damaged. Replace
worn or damaged blades and bolts in sets to
preserve balance.
Use only manufacturer-recommended
replacement parts and accessories.
Operation
Do not operate the engine in a confined
space where dangerous carbon monoxide
fumes can collect. Breathing exhaust fumes
can be fatal.
Edge only in daylight or in good artificial light.
Always be sure of your footing on slopes.
Walk, never run.
Use extreme caution when reversing or
pulling the edger toward you.
Read owner/operator’s manual.
Always wear eye and hearing
protection.
Keep children and others away
from unit while operating.
Never direct discharge toward
other people. Thrown objects
can cause injury.
Always keep hands away from
rotating parts.
Always keep feet away from
rotating parts.
WARNING: Fuel is highly
flammable. Take the following
precautions:
1. Store fuel in containers
specifically designed for this
purpose.
2. Refuel outdoors only and do
not smoke while refueling.
3. Add fuel before starting the
engine. Never remove the
cap of the fuel tank or add
fuel while the engine is
running or when the engine is
hot.
4. Avoid spillage: if fuel is
spilled, do not attempt to start
the engine but move the
machine away from the area
of spillage and avoid creating
any source of ignition until
fuel vapors have dissipated.
5. Tighten all fuel tank and
container caps securely.
To Next Page
