GB - 16
Ariens Dealers will provide any service, parts
or adjustments which may be required to
keep your unit operating at peak efficiency.
Should engine require service, contact an
Ariens Dealer or an authorized engine
manufacturer's service center.
MAINTENANCE SCHEDULE
NOTE: Some working conditions (heavy
loads, high ambient temperatures, dusty
conditions, or airborne debris) may require
more frequent service.
See engine manual for further maintenance
and troubleshooting information.
After first 5 Hours of operation.
Replace Engine/Blade Control Cable
every 500 Hours of operation.
CHECK ENGINE/BLADE
CONTROL
The engine and blade must stop within
3 seconds after releasing the control. If the
engine and blade continue to run, adjust or
repair control immediately. See
ENGINE/BLADE CONTROL ADJUSTMENT
on page 22.
MAINTENANCE
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
MAINTENANCE
SCHEDULE
Service Performed Before
Each
Use
25 100
Check Engine/Blade
Control
•
Check Wheel Drive
Control
•
Check Grass Bag •
Clean Unit •
Check Engine Oil •
Check Mower Blade •
Check Drive Belt •
Check Fasteners •
Check Air Cleaner •
Change Engine Oil
•
Replace Oil Filter •
General Lubrication •
Check Spark Plug •
Check Engine
Cooling
•
Check Muffler •
Replace
Engine/Blade Control
Cable
•
To Next Page
Loading...
