Ariens Pro 28 User Manual (English)

Other manuals for Ariens Pro 28

Questions and Answers:

M
monica86Aug 1, 2025
Why won't my Ariens Pro 28 Snow Blower engine crank or start?
- R
  Rhonda VanceAug 2, 2025
  If your Ariens Snow Blower engine won't crank or start, there are several possible reasons. First, make sure the fuel tank isn't empty and fill it if needed. Next, check that the fuel shut-off valve is open. Also, ensure the key switch is in the run position. If these steps don't work, the issue might be dirt around the governor/carburetor, which you should clean. Finally, consider checking the starter and its connections, as either the ignition switch starter circuit or the electric starter itself may be faulty.
D
Donald McguireAug 7, 2025
Why is my Ariens Pro 28 not throwing snow properly?
- S
  Sarah ClineAug 7, 2025
  If your Ariens Snow Blower unit throws snow poorly or not at all, several factors could be responsible. Start by checking the shear bolts; if they are broken, replace them. Ensure that ice or debris is not obstructing the auger; if so, turn off the engine and disengage the auger before removing any obstructions. Another potential issue is the attachment drive belts, which may be slipping, worn, or damaged, requiring adjustment or replacement. Lastly, if the impeller is frozen, move the unit to a warm place to thaw it.
W
willisannetteAug 13, 2025
Why does my Ariens Pro 28 engine keep stopping?
- E
  Emily OliverAug 13, 2025
  If your Ariens Snow Blower engine stops, it could be due to several reasons. First, check if you are out of fuel and refill the tank if necessary. Another common cause is a closed fuel shut-off valve, so make sure it is open. A polluted fuel supply can also cause the engine to stop; in this case, replace the fuel with clean fuel. A faulty spark plug might be the culprit, so try replacing or cleaning it. Finally, a plugged fuel cap vent can also cause this issue, so replace the fuel cap.
B
brian17Aug 19, 2025
What to do if my Ariens Pro 28 Snow Blower does not operate in forward or reverse?
- U
  ucannonAug 20, 2025
  If your Ariens Snow Blower is not operating in forward or reverse, it could be due to a few reasons. One possibility is a worn-out friction disc, which would need replacement. Another cause could be slack in the traction cable; to resolve this, loosen the jam nut on the cable, remove the slack, and then tighten the jam nut. The traction belt might also be the problem, requiring repair or replacement. Lastly, the speed selector might not be properly adjusted, so you should adjust it.
M
Mathew Murphy DDSAug 26, 2025
What causes small rubber beads to collect in the frame of my Ariens Pro 28 Snow Blower?
- M
  Michael CharlesAug 27, 2025
  The collection of small rubber beads in the frame of your Ariens Snow Blower is typically due to normal friction disc wear. However, if you notice large chunks or pieces of rubber, it indicates that the friction disc should be checked and replaced if necessary.

Ariens Pro 28 Specifications

General

Engine Brand	Ariens AX
Clearing Width	28 inches
Start Type	Electric Start
Fuel Type	Gasoline
Stage Type	Two-Stage
Number of Speeds	6 Forward / 2 Reverse
Chute Rotation	200°
Auger Material	Steel
Drive System	Disc-O-Matic
Chute Control	Remote
Engine Displacement	306cc
Intake Height	21 inches
Auger Diameter	14 inches
Impeller Diameter	14 inches