Ariens Professional 21 938024-SSR

Questions and Answers

G
George GreeneAug 11, 2025
Why won't my Ariens Snow Blower engine start?
- C
  Christina MooreAug 11, 2025
  There are several reasons why your Ariens Snow Blower engine might not start. It could be due to the engine switch being in the stop position (push it to the run position), a closed fuel valve (turn it to the on position), an empty fuel tank (fill it with fuel), the engine not being primed (press the primer bulb twice), a disconnected spark plug wire (connect the spark plug), the choke being off (turn the choke control knob to the on position), excessive fuel in the engine cylinder (turn the choke control knob to the off position and reattempt starting), or a faulty spark plug (replace it). In some cases, the engine itself might be faulty, requiring assistance from your Ariens Dealer.
W
William SchmittAug 17, 2025
Why does my Ariens Professional 21 938024-SSR engine start hard or run poorly?
- A
  allisonantonioAug 17, 2025
  If your Ariens Snow Blower engine starts hard or runs poorly, it could be due to a fuel mixture that is too rich (turn the choke control knob to the off position). Another potential cause is a faulty, fouled, or incorrectly gapped spark plug (clean and correctly set the spark plug gap). Also, a blocked fuel cap vent can cause this issue (install a new fuel cap).
S
Stephen ConnerAug 23, 2025
How to prevent excessive snow left behind by my Ariens Snow Blower?
- B
  Brian PetersonAug 25, 2025
  If your Ariens Snow Blower is leaving excessive snow behind, the scraper blade is likely worn. You should replace the scraper blade.
J
johnperezAug 29, 2025
What to do if my Ariens Professional 21 938024-SSR Snow Blower doesn't discharge snow?
- T
  Timothy CoxAug 30, 2025
  If your Ariens Snow Blower isn't discharging snow, the auger drive belt might be loose or damaged (replace the belt or adjust the auger control cable). Alternatively, the discharge chute could be clogged with snow (stop the engine, close the fuel valve, and clean the discharge chute and auger housing with a tool, being careful not to use your hands). Worn or damaged auger paddles can also cause this issue (replace the auger paddles).
A
Andrea GomezSep 5, 2025
What to do if there is excessive vibration in my Ariens Professional 21 938024-SSR Snow Blower?
- L
  Lauren ParkerSep 5, 2025
  Excessive vibration in your Ariens Snow Blower could be due to loose parts or damaged auger paddles. Inspect the machine for any loose or missing hardware. If the auger paddles are damaged, replace them.

Ariens Professional 21 938024-SSR Specifications

General

Clearing Width	21 inches
Intake Height	16 inches
Weight	178 lbs
Chassis	Steel
Warranty	3-Year Limited Consumer / 1-Year Limited Commercial
Auger Type	Serrated Steel
Starting System	Electric Start
Starter	Electric Start
Skid Shoes	Adjustable