Ariens RT7018 - Storage; Troubleshooting

GB - 15
Check each item in Before Storage in the Maintenance
Schedule. See Engine Manual for detailed instructions
on preparing the engine for storage.
Unit
Store unit in a cool dry protected place.
Inspect unit for visible signs of wear or damage. Order
any parts required and make necessary repairs to
avoid delays when beginning use again.
Clean unit thoroughly.
IMPORTANT: NEVER spray unit with water or store
unit outdoors.
Touch up any chipped or scratched painted areas to
avoid rust.
Engine
When storing tiller for an extended period, refer to
Engine Manual.
STORAGE
WARNING: AVOID INJURY. Read and
understand Storage Safety Rules in Safety
section before operating.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will not
start.
1. Fuel tank empty.
2. Fuel shut off valve in closed position.
3. Engine problem.
1. Fill fuel tank with clean, fresh gasoline. See
Engine Manual for proper type and grade.
2. Place fuel shut off valve in open position.
3. See engine manual.
Engine runs
roughly.
1. Restricted air cleaner.
2. Restricted fuel cap vent.
3. Engine trouble.
1. See engine manual.
2. See engine manual.
3. See engine manual.
Unit does not till in
forward/reverse.
1. Clutch cables need adjustment.
2. Attachment jammed or damaged.
1. Adjust clutch cables. See Service and
Adjustments.
2. Stop engine and remove spark plug wire.
Clear obstruction or repair unit before
operation.
Tines operate
slowly.
1. Clutch needs adjustment or repair.
2. Tines damaged.
3. Engine problems.
1. Adjust clutch cables. See Service and
Adjustments.
2. Repair or replace before operation.
3. See engine manual.