ARIETE 9020 - Troubleshooting

TROUBLESHOOTING
Thefollowingcasesmaynotalwaysbeamalfunction,pleasecheckitbeforeaskingfor
service.
Trouble Analysis
Does not run
lftheprotectortriporfuseisblown.
Pleasewaitfor3minutesandstartagain,pro-
tectordevicemaybepreventingunitfromwork-
ing.
lfbatteriesintheremotecontrolareusedup.
lf the plug is not properly plugged.
Stops running during operation lf the set temperature is close to room tempera-
ture, you can lower the set temperature.
Airoutletbeblockedbyobstacle.Taketheob-
stacle away.
Runsbutdoesnotcool lf the door or window open.
lf there is other heater applianceworknearby,
likeheaterorlamp,etc...
Theairlterisdirty,pleasecleanit.
Airoutletorintakebeblocked.
Set temperature is too high.
Does not run and water full indicator
is lit
Drainthewaterintoapreparedcontainerbythe
drainage pipe on the rear panel of the unit. lf it
stilldoesn'twork,pleaseconsultaqualiedtech-
nician.
LED display "E1"
Thetemperaturesensorerror
LED display "E2" ThecoiIsensorerror
36
EN