TROUBLESHOOTING
Warning!
Immediately switch off the appliance in case of operational faults and electrical failures. Unplug it from the socket-
outlet. Wait for the appliance to cool down.
PROBLEM CAUSE REMEDY
On light off Not plugged in Check that the appliance is properly plugged in. Check that
there is current on the power supply line. Try to plug the
appliance into another socket-outlet. If the problem continues,
contact an Authorised Service Centre.
No steam comes out of
the nozzle
Pump activation button (B)
not pressed
Press the button (B) and activate the pump.
The appliance is not ready
for use
Switch the appliance on, wait 30 seconds and activate the
pump.
Water shortage in tank
Fill the tank up to the level marked MAX.
Incorrect insertion of the tank
in its seat
Remove the tank and put it back in, making sure it is in the
right position.
The steam exit holes may be
blocked by limescale
Contact an Authorised Service Centre.
Unexpected increase
of the noise level of the
pump
Water shortage in tank Turn off the appliance and ll the water tank.
Incorrect insertion of the
tank in its seat
Remove the tank and put it back in, making sure it is in the
right position.
Water leakage from the
nozzle
Possible condensation
residue in the steam duct
Press the steam dispensing button until you see steam
coming out. Position a soft cloth so as to not dampen the
oor. If water continues to come out, turn off the appliance.
Wait at least 5 minutes so that the steam head and cloth cool
down. Try again.
To Next Page
Loading...
