Ariston LFP 5P31 WLT X

Questions and Answers

M
Mary TurnerAug 18, 2025
Why is my Ariston Dishwasher not working?
- M
  Matthew DavisAug 18, 2025
  Your Ariston Dishwasher might not be working because it is not switched on, the door isn't closed properly, or the 'Start Delay' option is activated. Ensure the appliance is switched on and check the household circuit fuse. Make sure the door is fully closed. If the 'Start Delay' option is on, the dishwasher will start when the set time elapses; restart the cycle by switching the dishwasher off and on, selecting a new cycle, and pressing START/Pause.
S
Shelby PriceAug 21, 2025
Why are my dishes not drying in my Ariston LFP 5P31 WLT X?
- S
  samanthaellisAug 21, 2025
  If your dishes are not drying in your Ariston Dishwasher, it could be because the selected program doesn't have a drying phase, or the rinse aid has run out or the dosage is inadequate. Verify on the programs table if the selected program has the drying phase. Add rinse aid or adjust the dosage levels higher.
J
John WilsonAug 23, 2025
What to do if my Ariston LFP 5P31 WLT X Dishwasher shows CHECK SALT or ADD SALT?
- S
  Sophia ThompsonAug 23, 2025
  If your Ariston Dishwasher displays 'CHECK SALT' or 'ADD SALT', it means the salt reservoir is empty. Refill the reservoir with salt and adjust the water hardness.
C
Curtis NashAug 26, 2025
What does F2 mean on my Ariston Dishwasher and how to fix it?
- M
  Maria BurchAug 26, 2025
  If your Ariston Dishwasher displays 'F2', it could be due to dirty filters or spray arms, too little water in the system, an incorrectly fitted drain hose, high foam levels, low water pressure, or a kinked water inlet hose with clogged filters. Clean the filters and spray arms. Ensure concave items are facing downwards. Fit the drain hose correctly, and repeat the cycle without detergent or wait for the foam to disappear. Make sure the water tap is fully open and the water inlet hose isn't kinked, and that the inlet filter is clean.
H
Haley FernandezAug 28, 2025
What does F3 mean on my Ariston Dishwasher and how to fix it?
- Z
  Zachary DavisAug 28, 2025
  If your Ariston Dishwasher displays 'F3', it indicates dirty filters, a kinked drain hose, or a closed syphon hose connection. Clean the filters, ensure the drain hose is not kinked, and remove the closure disk from the syphon hose connection.
J
Joseph MeyersAug 30, 2025
What to do if my Ariston LFP 5P31 WLT X Dishwasher shows CHECK RINSE AID or ADD RINSE AID?
- J
  Jennifer MooreAug 30, 2025
  If your Ariston Dishwasher displays 'CHECK RINSE AID' or 'ADD RINSE AID', it means the rinse aid dispenser is empty. Refill the dispenser with rinse aid.
S
simpsonmalikSep 1, 2025
How to fix F6 error on Ariston Dishwasher?
- B
  Brandon MaySep 1, 2025
  If your Ariston Dishwasher displays the 'F6' symbol, it indicates that the water pressure is too low, or the water inlet hose is kinked or the inlet filters are clogged. Ensure the water tap is fully open during water inlet (minimum capacity: 0.5 liters per minute). Also, make sure the water inlet hose is not kinked and the inlet filter in the water tap connector is not dirty or clogged.
T
Tommy JonesSep 4, 2025
What does Fx mean on my Ariston LFP 5P31 WLT X?
- L
  Laura MaldonadoSep 4, 2025
  If your Ariston Dishwasher displays 'Fx', it indicates a technical defect. Call customer service and state the fault displayed. Close the water tap.
M
Michael MillerSep 6, 2025
Why is my Ariston LFP 5P31 WLT X Dishwasher excessively noisy?
- C
  Christopher WhitakerSep 6, 2025
  An Ariston Dishwasher can be excessively noisy if the dishes are rattling against each other or if an excessive amount of foam has been produced. Arrange the crockery correctly. If there is excessive foam, the detergent has not been measured out correctly or it is not suitable for use in dishwashers. Restart the current cycle by switching the dishwasher off, then on again, selecting a new program, and pressing START/Pause without adding any detergent.
J
John ClarkSep 8, 2025
What to do if my Ariston LFP 5P31 WLT X shows PRESS START AND CLOSE THE DOOR?
- J
  Joan GarciaSep 8, 2025
  If your Ariston Dishwasher displays 'PRESS START AND CLOSE THE DOOR', it means the door was not closed within 4 seconds of pressing the start button. Press the start button again and close the door within 4 seconds.

Ariston LFP 5P31 WLT X Specifications

General

Type	Freestanding
Dimensions (H x W x D)	85 x 60 x 60 cm
Display Type	Digital
Maximum Delay Start	24 h
Width	60 cm
Depth	60 cm
Height	85 cm
Delay Start	Yes
Half Load	Yes
Drying Performance	A
Washing Programs	Eco, Intensive, Normal, Rapid