8 1200C-2000C Fire Alarm Control Panel and Repeater User Manual
Fire brigade buttons and indicators
Figure 5: Fire brigade buttons and indicators
1. Signal
2. Delay ON/OFF
3. Fault/Disable
4. Stop fire brigade
Note: Some features can only be accessed if the key switch is enabled (see “Key
switch operation” on page 2).
Table 6: Description of fire brigade LED indicators
LED indicator Key switch position Description
Signal Enabled Push this button to activate the fire brigade
notification. A red LED indicates that a signal has
been sent.
Delay ON/OFF The LED indicates that the fire brigade delay has
been toggled ON or OFF.
Fault/Disable Enabled Push this button to disable the fire brigade
notification. The LED is steady when the feature is
disabled and flashes when a fault is detected.
Stop Fire brigade Enabled Push this button to stop the fire brigade notification A
yellow LED indicates that the signal has been
stopped.
Note: Functionality of the Signal and Stop Fire Brigade buttons is defined by the
control panel operating mode.
To Next Page
Loading...
