Why Aritech Security System device fails to operate?
If an Aritech Security System device isn't working, the control panel might have incorrect cause and effect programming. You should verify the cause and effect programming on the control panel.
What to do if Aritech Security System shows no response or is missing?
If your Aritech Security System is not responding or is missing, it could be due to an incorrect address setting or incorrect loop wiring (polarity reversed). Check the address setting and loop wiring to resolve this issue.
General| Operating Voltage | 9-16VDC |
|---|---|
| Operating Temperature | -10°C to +55°C |
| Technology | Passive Infrared (PIR) |
| Detection Principle | Infrared |
| Detection Angle | 90° |
| Humidity Range | 95% RH non-condensing |
| Tamper Protection | Yes |
| Current Consumption | 20mA (typical) |
To Next Page
