Aritech EV400AM Series User Manual

- 1 -
EV400AM SERIES DETECTOR
fig. 1a
fig. 1b
fig. 1c EV435AM/EV436AM fig. 1d
fig. 1e EV455AM/EV456AM
fig. 2
fig. 4 fig. 9 fig. 10 fig. 11 fig. 12
fig. 5 fig. 6 fig. 7 fig. 8
fig. 3
"CV" = Control Voltage
Either "Low" or "High" Control Voltage may be used "Low" = 0 Volt
Select the appropriate Control Voltage Setting. "High" = 12 Volt
EV435AM/EV436AM/EV455AM/EV456AM
Switch Description On Off
1 LED indication LED's on LED's controlled
2 Range max. stated range min. stated range
3 Processing Bi-curtain Standard-4D
4 Trouble output ETO + alarm relay; ETO
tech. fault; ETO only
5 AM Sensitivity High Standard
6 Reset Tr.output After Walk test Authorized reset
7 Tr. output indic. Only in disarm mode Immediately
8 Contr. Polarity Active High Active Low

Aritech EV400AM Series Specifications

General

Product Series	EV400AM Series
Category	Security Sensors
Manufacturer	Aritech
Type	Motion Detector
Operating Voltage	9-16 VDC
Output Type	Relay
Alarm Memory	Yes
Operating Temperature	-10°C to +55°C
Technology	Passive Infrared (PIR)
Alarm Output	Normally Closed (NC)
Tamper Output	Normally Closed (NC)
Sensitivity Adjustment	Yes
Housing Material	Plastic
Mounting	Wall
Compatibility	Standard alarm panels
Detection Principle	Passive Infrared

Summary

Technical Data

Input Power and Current Consumption

Details on voltage requirements, ripple, and current draw during normal and alarm states.

Target Speed Range

Specifies the detection speed limits for different detector models.

Alarm Output

Describes the type and characteristics of the alarm relay output.

Temperature Limit and Humidity

Outlines the environmental operating conditions for the detector.

Physical Specifications and Range

Covers dimensions, weight, number of zones, and maximum detection range.

Housing Compliance and Certifications

Lists standards and certifications the detector housing meets.

Mounting and Installation

Siting the Detector

Guidance on optimal placement to avoid false alarms and ensure effective detection.

Remote Walk Test LED Control

Instructions for enabling and using the walk test function via remote input.

Switch Settings and Configuration

Explains the function of each DIP switch for detector configuration.

Reset Conditions

Details how different detector states are reset or cleared.

Alarm Memory Operation

Describes how the detector manages and indicates alarm memory.

Coverage Pattern Selection

How to adjust the detection pattern using mask labels.

Window Masking

Specific instructions for using masks to prevent false alarms from windows.